Newly built PC not booting

Troubleshooting

Hi everyone, I'll cut to the chase and ask if it's possible that my CPU (a friend's used R5 5600X) that I accidentally broke off some pins for (4 along the bottom right if the gold arrow is to the top left -- 3 voltage, 1 memory controller) may be preventing my newly built PC from booting?

  • Crucially, the mobo does supply power to peripherals connected to the rear and front I/O, which is the only thing that does work. Having said that...
  • No fans spin up, no integrated speaker nor any diagnostic LEDs on this model of mobo, so I'm deaf and blind there, and GPU also doesn't spin up.
  • The rest of the components are otherwise new.
  • I've gone through most of Tom's Hardware troubleshooting checklist, specifically: Front header pwr/reset/LED lead positions were double checked, RAM (that's on the mobo QVL) was reseated and tested in single / no stick configs, SSD/HDD reseated and also removed during boot, 8-pin EPS & 24-pin ATX cables seated properly with the right cables in the right slots on my PSU (as far as I can tell), BIOS flashed to the latest version prior to doing anything, no loose wires, screws or thermal paste on the mobo, no ESD-strap but very careful whilst building in a slightly humdified room on a non-conductive surface, GPU double checked for seating but also tested boot without it

and the only other thing I can think of is that I might need to breadboard the whole build as the mobo does have a backplate heatsink that may be making contact with the case? Still, that sounds like such a dumb oversight by the mobo manufacturer (and I'm only using the standoffs that were preinstalled by the case manufacturer, nothing else should be underneath it).

Parts:

  • CPU: Borked Ryzen 5 5600X
  • PSU: Corsair SF750
  • MB: Gigabyte Aorus X570SI Pro Ax rev 1.1 (Q-Flashed to F3 BIOS prior to CPU installation)
  • RAM: T-Force DARK Zα DDR4 3600Mhz 2x16GB (again, should be on the QVL)
  • GPU: MSI GeForce RTX 2070 Super Ventus OC (using an HDMI 2.0? cable right now)
  • SSD/HDD: 2TB WD SN770 Gen 4.0 NVMe & spare 2.5" HDD
  • Case: CoolerMaster NR200P
  • Cooler: CoolerMaster Hyper 212 Black w/ MasterGel paste (did 1 drop on the CPU IHS)
  • Case Fans: 2x CM Sickleflow 120mm (top exhaust), 2x Arctic P12 Slim 120mm (bottom intake)

If anyone's wondering how I borked the CPU pins: well, they may have been damaged in transit, or due to my own panic. Whilst seating the CPU cooler, I didn't realize how much force you needed for the Hyper 212's mounting screws, and thinking I was damaging the CPU, stopped halfway through the installation and ripped the CPU right out of the socket whilst removing the cooler. Tried bending the pins back, but did a hack job of it and 4 came off. And yes the CPU was aligned to the gold arrow and the retention arm was lifted and closed respectively prior to and after installing it.

Anyway, thinking of bringing it into a shop, but not sure what they'd be able to do that I couldn't. I'd love to have a spare AM4 CPU to test with, but I'm a bit traumatized to order one and the prices have only gone up after the holiday stock got sold out here in Canada.

Would appreciate any insights 🙏

https://imgur.com/a/DXqCEI6 reference images attached

Posted Jan 8, 2023, 9:26 PM UTC

01
sdwvit•

You need a new cpu.

1