I found the limits of the 3rd gen mr cool diy multi zone
Last spring I installed the mr cool diy 3rd gen 4 zone 36k btu in my 1100 sq ft home. It’s a under insulated, r11 in the walls and r19 in attic. The temps were -5 f last night and climbed to 3 degrees f this morning. This is the coldest it’s been with these units.
The hallway thermostat for the backup heat (which kicks on at 50) reports 58 degrees. I’ve attached a screenshot of each unit. The temp on the bottom of each tile is what it is set to and the temp to the right is what the sensor indicates.
https://i.imgur.com/AgvMpEB.jpg
It’s certainly survivable and temps like this only happen like once a year in my area. But if I lived anywhere colder I’d probably go with a hyper heat unit either from one of the big brands or even mr cool.
Posted Feb 4, 2023, 4:14 PM UTC
Have you tried just turning the thermostats all the way up? Even after calibration mine seem to stop heating about 6 degrees below set point. So I just turn them 6 degrees over to hit what I want. Before calibration they were like 19 degrees off.
No I haven’t but I’ll give it a try if the weather gets cold enough again. Now that it’s 15 degrees f out the house is catching up fairly quickly.