Stupid Question - What's better? Turning up the volume on your computer or on your music player (itunes/spotify/youtube etc etc)
Just wondering.
Posted Oct 9, 2012, 1:38 AM UTC
Just wondering.
Posted Oct 9, 2012, 1:38 AM UTC
If you have Windows Vista/7, probably Windows audio.
spotify/youtube
Also, turning the volume up(as long as it doesn't go past 100) actually boosts dynamic range and such, especially if you have 16 bit or less depth.
1/ Turn the player volume to 100% SOFTWARE ( VLC goes up to 200% for example ... )
2/ If not enough turn the computer volume up to 50%
3/ If still not enough turn Amp volume to 50%
Why ? Trying to mminimize distortion by reaching each components limits
So can there be distortion when the output from pc/soundcard is at 100?
Distortion tends to increase when the sound is very low or very high as you push the circuits to it's limits. When you set the sound at 100% it will distort but I wouldn't worry, if you can't hear it what's the problem? Sound is highly subjective and with modern hardware distortion is not really a problem anymore
Set your PC's and software's volume controls all to 100% for the output in question. You will minimize clipping as well as not losing any fidelity. Adjust the volume at your amp as needed.
Why? Running your PC with the volume below 95-100% actually removes data from the audio bitstream (midprocess, at the player level, which is digital). You're sending less information (bitwise) to the D/A converter, and on to the internal preamp on the soundcard, so you're getting less information, as opposed to quieter sound. At 100% the sound signature is complete and un-mucked. That's the signal you want to send to the amp. Don't send anything over 100%, or you will likely overdrive the signal and wind up with clipping on the analog/amp side.
Once the sound is at the amp, that's where you control volume. The volume knob on the amp attenuates the analog output, as opposed to the digital portion of the stream in the software. You want a full signal to attenuate, not a weak signal to boost. Let the amp do the work, as amps by nature run full bore and use an attenuator to quiet the amplified signal output.
So the proper way to use an amp is to put all computer volume at 100% and control the amp volume?
Correct. You don't want the software messing with the bitstream, which is what it does when it digitally lowers the volume. Send the complete stream to the amp, and attenuate it on the analog side. Unless your music data is already overdriven or oversampled, you should have great dynamic range and clarity with minimal distortion.
I keep software at full and simply adjust with the windows master volume fader, and adjust each program in windows volume mixer.