Sock completely encased. More in comments.

Question
Sock completely encased. More in comments.

Posted Feb 25, 2023, 6:40 AM UTC

28
VerticalTwo08OP•
  1. Why does this keep happening. This has happened before but usually caught it before it was this bad. This time I had left the house for a few hours and came back to this?
  2. I couldn’t get the sock out with out it being torn apart. Am I able to continue printing with out it? 3.. The hot end itself is still Covered in plastic what’s the best way to clean the the box above the hot end? video of hot end
  3. The printer is a ender 3.

Thanks for the help in advance.

1
Jeb0211•
  1. Either your nozzle/throat tube is not sitting flush with each other, thus leaking plastic, or the sock is coming off during printing and blocking filament from normally depositing onto the part you are printing.
  2. You can print without the sock. I don't like socks actually.
  3. To clean the heat block, heat the hotend to 100~150°C to soften the plastic. You can then cut it using side cutters.
1
VerticalTwo08OP•

Do I have to worry about damaging anything around the block such as wires and and the fans? Or is everything in there robust enough I don’t have to worry about it much?

Also what do the socks even do? I just assumed it was important since it came with it.

1
Jeb0211•

Yes, the wires are quite fragile. Good luck.

Socks insulate the heat block and reduce the temp fluctuation. Also you won't need to clean the hotend as much since it's protected by the sock.

1
p8willm•
  1. Use a heat gun to soften the plastic. Be careful of the wires, especially those to the thermistor as they are fragile. Also be careful not to burn yourself.
1
VerticalTwo08OP•

Should I just take apart the entire head assembly? To clean it?

1
p8willm•

Don;t have too. Just be sure you tighten it up when you are done. YT has videos and Google will find text about tightening the nozzle.

1
VerticalTwo08OP•

I’ve changed out the nozzle before. So yes I will see if it’s on tight enough. But I mean the plastic built up so bad it went up above the block almost reaching the fans. I’m talking about that stuff. Should I take it apart , such as the fans and such, to get that stuff out?

1