r/lianli•
Comm_Cody

Looking for replacement screws/dimension of the long screws for Lian Li 2 Mesh RGB

Was installing my new SL120 V2 today. Installing on the bottom, the screws provided with the fans were too big to fit through the drilled holes that held the SSD mounting area.

I bought the case open box so the person who returned it didn't return everything. Does anyone know the dimensions of the screws that are marked as G in the manual? They look like long radiators screws but have a very narrow center.

I currently have zip ties holding the fans in place but would like to find more permanent solutions without resorting to a drill bit to install/secure the fans

Posted Mar 23, 2023, 11:11 PM UTC

14
LIANLI_TECHSUPPORTMod•

Are you trying to mount them to a radiator? Which case are you trying to mount them into? The standard case fan screws should work fine.

1
Comm_CodyOP•

No, am not mounting them to a radiator.

I am mounting them to the bottom (but above the PSU cellar) of the Lancool II Mesh RGB. The product page and manual says that both the 2.5 SSD mounting plates need to be removed to fit the two 120mm fans in there.

When I removed the two mounting plates, the holes for the screws is too small for the case fans screws to fit in unless I take a drill bit to it.

I suspect Lian Li offered custom screws in the case for this purpose which I don't have since I bought the case open box which had the screws missing.

The screws in question are the screws marked G in the manual, linked here ( https://www.manualshelf.com/manual/lian-li/lancool-ii-mesh-rgb-w/user-s-manual-catalan-english-italian/page-3.html )

I am just asking for what screws they are since the manual does not tell me what they are in any form.

1
LIANLI_TECHSUPPORTMod•

32mm x 6#32

1
Comm_CodyOP•

Screws worked but holes are not aligned on the case for two SL120 Daisy chained fans to screw in

Alas, the zip ties will be kept.

1
Comm_CodyOP•

to elaborate on, page 9 (https://www.manualshelf.com/manual/lian-li/lancool-ii-mesh-rgb-w/user-s-manual-catalan-english-italian/page-9.html ) shows what I am trying to do. yes the picture uses the old Boras fans, but as you can see, screw G goes down through the fan holes to then thread into the small holes. I merely wish to do this with my two SL120s that I have installed there and need to know what are the dimensions of screws G in question.

1