DRZ400 back wheel hard to turn in 1st gear, clutch pulled, bike off after valve clearance check - scared to turn bike on. Help
Hi, I just did my first valve clearance check on my Australian DRZ400e 2019. Everything went smooth and I reassembled the bike. Before the valve clearance check, the back wheel was easy to turn with the clutch pulled in first gear and bike off. During the valve clearance check, I did not use the socket to turn the engine to TDC but the method where I switch to 5th gear and turn the back wheel until its TDC. No problems here. After valve clearance check the back wheel is hard to turn with the bike off in first gear with clutch pulled. In neutral the wheel turns easy as before. The valves were in spec and I had the engine open for maybe 5-10 minutes. I was very careful and nothing dropped into the engine. All screws were torqued to specs. I did not open the clutch itself or the transmission and only opened the top cover.
Could this have anything to do with the method: While the bike is off, I switched gears from 1st to 5th gear using my hands to turn the wheel. I then turned the engine in 5th gear to get to top dead center to do my valve clearance check. Afterwards, I switched down from 5th gear to 1st gear again manually by turning the wheel with the bike off.
What I have already test is pulling he clutch and manually pushing in the clutch arm lever down at the engine further in to make sure the clutch is disengaged, which did not improve the wheel turning. Interestingly, when I switch to higher gears, the resistance of turning the wheel with clutch pulled is lower, with the lowest (almost normal) resistance in 5th gear. But 1st gear is super hard to turn still. When checking the oil stick, there is no oil, so I added about 200ml of oil, but there is still no oil visible on the stick. I dont want to just add more oil, since before the valve check the oil was full and I did not loose any oil from the bike during the check. I am afraid that oil went somewhere into the wrong place in the engine??? Should I keep filling in oil until I can see it on the stick? After refilling oil and switching gears up and down a couple of times and turning the wheel, still nothing changed. Maybe I have to actually turn the engine to make the oil flow where it is supposed to be?
I am scarred to switch the bike on. PS. my front forks are at the shop at the moment for suspension and revavling. The bike is sitting on a stand.
Thanks for your help!!!
Posted Apr 22, 2023, 7:32 AM UTC · edited
When you spun the back wheel earlier, and it was easy to turn, was the oil warm? I’ve never had a cold bike spin easily in gear. Mostly, I’m basing that on pushing them around the shop. If it’s not in neutral, and the oil is cold, there’s so much drag in the clutch that you just about can’t push it.