PC does not turn on after RAM swap + cleaning with compressed air, possible PSU fault?
EDIT: To add onto this, the MoBos RGB LED flashes green very briefly when I switch the PSU to from 0 to I (aka ON) when connected. If I remember correctly, that used to stay on before...
Hello y'all, I'm in need of your assistance and expertise, hope I filled this form out correctly, let me know if there's any additional info I can provide.
Any help is greatly appreciated, I've been at this for like 6h now and am at my wits end.
Current prime suspect is that the PSU died for some reason (compressed air or moving the PC outside to blow the dust out damaging it???)
Hardware
- Gigabyte Aorus Ultra X570
- RTX 3080 (PNY)
- 64GB (2x32) DDR4 Corsair Vengeance 3600MHz (CL18)
- *previous RAM was 4x8GB Corsair Vengeance 3200Mhz *
- AMD Ryzen 5900X
- beQuiet Dark Rock Pro 4
- beQuiet! Straight Power 11 750W
- various HDDs and SSDs (SATA and M.2)
- Fractal Design Define 7
Details about my problem
I ordered some new RAM to swap to 64GB total and when installing it earlier today, figured I'd also renew the thermal paste and clean the hardware with compressed air.
After putting everything back together, it won't turn on anymore. No mater if I attempt to start the MoBo, CPU, RAM only outside the case or everything together, the following happens:
As soon as the PC receives the start signal, the PSU turns on briefly, clicks twice (as in 2 destinctive click noises from inside of it) and the fan stops (I assume it turns off at that point). If installed the GPU also turns off its fans at this point. On the MoBo the light for CPU flashes once as well.
Additionaly, I cannot turn the PC back on unless I remove the power cord and replug it back in after 5-10 seconds, possibly indicating the PSUs surge protector kicking in / shortening out?
Current steps I've already tried
- Rebuilt the entire PC pretty much, took out MoBo, CPU/GPU and unplugged everything
- attempted starting the PC with CPU/RAM only outside of case
- Took out CPU twice and put it back in + cooler
- attempted using QFlash+ to flash a new BIOS (saw that on another post somewhere) --> PSU gives 1 click only as I press the Flash button
- put old RAM back in as I initially thought the new one was faulty.
- used 1 RAM stick at a time, one-by one
I unfortunately do not have any spare parts outside of the old RAM sticks. I will likely go to a store and buy a new PSU just to try that as I at least currently believe that's the faulty part.
Posted May 5, 2023, 9:50 PM UTC · edited
Look near the RAM area with a magnifying glass (if you need), particularly the top right corner.
Check for signs of burning / burnt fuses.
You can also like rest your finger over the areas too and feel for warm spots.
This happened to me when I swapped for 32GB sticks and one of the ram sticks were faulty causing me to burn a fuse. Luckily I got away with just scraping the bridged solder and the fuse ended up still being functional with new ram.
Thanks for the reply!
Just checked, no (immediately obvious) signs of burnt out fuses or any heat when I turn it on. It looks normal as far as I can tell but I don't know much about that sorta stuff :D
But interesting that stuff like that can happen.
Wait are the sticks in slot 2 and 4? Skip the one closest to the CPU, the next one over is #2 followed by an empty #3 and the last at the edge of the MB is #4