Maverick 88 changing stock and forend

I bought my Mav like 3 months ago. I like it but i wanna change the stock and forend to a wood one. I look into it and I find out I need a action slide assembly, I look into what size and I’m told 6 3/4. Fast forward to buying all the things I think I need. Action slide assembly doesn’t even fit my forend that I bought, supposedly for that size. Action slide assembly won’t fit over my magazine tube. Is there anyone out there that can help me figure out what size I might need for the slide assembly??

Posted May 7, 2023, 6:18 AM UTC

14
Ryanrealestate•

Might need to sand your fore end. The diameter of the tube should change right? 7&3/4 is the next one up. I just did this and put a hogue for end on and it was a tight fit

2
simiandominionOP•

So 7 3/4 slide or 7 5/8?

1
Ryanrealestate•

“Comparison of action slide lengths: top 7-5/8", bottom 6-1/2" Measure from top of threads to bottom of collar that holds the action bars. This measurement is critical to fit when ordering forearms or stock sets that include a forearm. For the most part, 20-year and older sporting shotguns and new tactical shotguns use the 7-5/8" slide. New sporting models have used the 6-1/2" slide for almost 20 years. There are exceptions, however. To be sure, measure! NOTE: Since 2006, most new 500®, 535® and 835® sporting shotguns with synthetic forearms may not use an action slide tube at all; rather, the pump handle will have two integral bars pinned into the handle itself. If you have one of these, you cannot use a forearm that was designed to go over an action slide tube without first buying the correct length tube and action slide tube nut.”

2
Johnny_Clay•

Concerning the length, you can get a new “nut” that’s extended to use with the shorter slide tube:

https://www.midwayusa.com/product/1004103484

As for it being the incorrect diameter, I’d need to see some pictures. Some of the slide tubes have little dimples hammered into them to take up some of the slack. It could be that those dimples were hammers in too far.

If that’s the case, you can push them back out with a screw driver (you might need to tap it lightly with a hammer).

1