[Help] Reaper is not detecting my legacy Katana-100
So, I've been away from recordings for several years but in the past I remember that I just installed everything (Reaper and BTS), set the devices in the preferences section and it was good to go. For some reason, I've done the same right (also armed the track for recording) now but Reaper does not detect any signal from my amp.
Can anyone tell me if I'm missing something? I'm using a legacy Katana 100 if that's important.
Thanks in advance for all the help!
Posted May 17, 2023, 6:55 PM UTC
13
Are you up to date on all updates/patches for the firmware on the katana?
Hello! Thank you for answering!
Yes, I've downloaded everything from the katana's page, installed the driver, installed the BTS, Installed Asio4All, but for some reason, nothing works.
The amp is detected by the pc and is possible to select in the preferences section. But even though I arm a track for recording, it doesn't pick any signal coming from it.
This is odd, because I've used it in the past and never had this kind of problem before.