r/prius•
rdrast

How bad will this be ? (2012 Prius)

240,000 ish miles, was heading to work today, and engine went to hell, low oil pressure warning, burning rubber smell, OBD shows "Crankshaft, camshaft position correlation bank 1 sensor a"

Going to have it towed to a dealer tomorrow, but is there any hope?

Last (2005) Prius went 375,000 miles before I traded it in.

Posted Jun 20, 2023, 10:12 PM UTC

517
rdrastOP•

Whelp, after looking at it in daylight, the serpentine belt is gone.

I'm keeping my fingers crossed that that is the root issue. It's at the Toyota service center now, but when they can look at it? Who knows.

And no, no mobile service here in Nowhere SC. The local mechanics won't even look at anything newer than maybe 2001, never mind a hybrid.

2
rdrastOP•

Sad update, losing the belt mis-timed the engine, and engine is toast. Quoted 10k complete to repair, $5300 for the engine. /sigh.

Time to look for a new (used) car.

2
unlimited_mcgyver•

Well low oil pressure can cause the correlation code. Did you have an oil change done lately? Maybe the plug fell out or leaked onto the exhaust. If you didn't drive too long with the oil light on you'll probally be ok

1
rdrastOP•

No, well, 3k ago, it was fine after. Only forced it to drive (with complaints, bad noises) to get it off the road to the shoulder ( cornfield grass here). Smoke and rubber smell was coming from engine compartment.

2
unlimited_mcgyver•

Sounds like it's shot buddy.

3
rdrastOP•

/sigh fearing that myself. But if service center can give me another 100k, for under $5k, I'll go with it.

I have zero luck with most engines, but Toyota's have always been amazing for me.

2
unlimited_mcgyver•

You can check out car-part.com and see what engines are going for in your area. Plus 16 to 20 hours labor ~ $3k. you might come in under 5k if you provide the motor, once a dealer marks it up it will prolly be close to 4000 for the engine alone

2
Nippon-Gakki•

Jeeze, that sucks. I haven’t heard of many failures like that. Even if it’s the engine, low mile JDM pulls aren’t all that expensive. I swapped mine a while ago and it’s been great. You should be able to get an engine and installation for under $5k.

1
the_perkolator•

See if you have mobile service in your area. Here in CA I had a mobile HG service work on mine, but they also offer whole engine swaps as a mobile service too! That full swap was somehow cheaper than just the HG from most of the shops I called

1