Tight pocket question
If I wanted to have a table recovered how would I go about tightening the pockets?
Is there a cheap way to do it?
What is the proper way to do it? Say if I wanted to tighten them up a half inch undersize? This will require new rubber cut at very specific profiles wouldn't it?
Posted Jul 20, 2023, 4:21 PM UTC
10
There is always a cheap way but I'll warn you, you get what you pay for. The cheap way is called 'shimming' the pockets which is simply gluing cushion facings together. Cushion facings are a thing piece of rubber created to be the perfect thickness individually for play in the pocket. Adding facings is a shortcut additional facings in the pockets change how the pockets accept the balls as well. With double or triple shimmed pockets, you end up with dead pockets, meaning the balls act like they are either hitting wood instead of a single facing, or a trampoline, kicking the balls out of the pocket depending on the material used to shim the pockets. Additional facings also deaden the points of the pockets. It is a shortcut for a mechanic to get paid to do something that really doesn't work as intended.
The proper way to do the job is to extend the sub-rail using wood. This involves replacing the bumpers and cloth because both have to be removed from the rail in order to extend that sub rail. You need new bumpers and cloth because once you do the extension, your cushions and rail cloth will be too short lengthwise. Now, when you start extending the sub rails, the MOST IMPORTANT thing to correct is the miter angles. If you don't, you end up tightening the pocket openings and you also close the throat of the pocket at the same time. Making that mistake is unavoidable when 'shimming' because all you're doing is gluing facings on top of each other.