Source
ImaTotalNoob•

Maybe acceleration/jerk settings have been changed in the slicer & are overriding stock values when the gcode starts printing

1
Sharp-Reason-4004OP•

Hmm, the problem is still there when I print slower though. I would rather fix the sound than print slower.

1
Stoned-Avocado•

Record some sick electro tunes?

1
Chompbox•

Axis rods sufficiently lubricated? I experienced this noise when the ball-bearing jackets were too dry.

1
mropitzky•

I experienced a similar noice when my belts were far too tight on my ender 3, maybe try listening them a tad and see if the noise is reduced?

1
floreno007•

Adjust the stepper motor driver.

1