Source
r/AnycubicPhoton•
EvolvedA

Autofeed extension cable

Troubleshooting

I recently got my M3 Max and after a lot of trial and error my prints are becoming bigger, to a point where I will be needing the auto feed option. The problem is, the cable and tubing is rather short, and I'd prefer not always having to turn the whole printer when changing the bottle, so I'd like to extend the tubing and the cable. Extending the tubing is not an issue, but I am not sure which connector they use on the cable.

Does anyone know which connector is used for the auto feed bottle cap? Is it a JST-XH 3-pin connector? The connectors on the motherboard look a lot like that, but I wonder if anyone here has already figuered that out and could confirm it.

Thank you!

Posted Jul 31, 2023, 10:41 AM UTC

11
AutoModeratorMOD•

PLEASE UPVOTE THIS COMMENT IF THE ANSWER CAN BE FOUND IN THE BEGINNER'S GUIDE or the FAQ! If your post is about Troubleshooting, it should contain information about the print along with any screenshots or photos.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1
AutoModeratorMOD•

PLEASE UPVOTE THIS COMMENT IF THE ANSWER CAN BE FOUND IN THE BEGINNER'S GUIDE or the FAQ! If your post is about Troubleshooting, it should contain information about the print along with any screenshots or photos.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1