KR1 - replace MCPCB
Hi all,
ordered a KR1 but Hank accidentally sent it with the wrong LED. He offered to send a new MCPCP with the correct LED. How difficult is it for a noob to replace the MCPCB?
Posted Sep 8, 2023, 5:56 AM UTC
Hi all,
ordered a KR1 but Hank accidentally sent it with the wrong LED. He offered to send a new MCPCP with the correct LED. How difficult is it for a noob to replace the MCPCB?
Posted Sep 8, 2023, 5:56 AM UTC
If you can solder, the KR1/D1 isn't too bad as there's no aux board.
It's easy but the wrong solder iron tip can make the job a pain. Use the fattest tip you have and crank up the heat. Get position just right so you get the perfect contact on the first try. That includes getting the wire ready in the perfect spot with your tweezers. Don't forget a little flux, id makes everything easier (and that's what cleans the contacts for a good clean joint). Wet the tip of iron.
The last step is actually touching the wire over the solder spot, letting everything melt while holding th wire in place. It takes 2 seconds (more if your iron is an older low power model), and you're done. It's the setup that takes a minute.
Very easy, you do need a soldering iron and some stuff tho
I have a soldering iron, what else do I need?
Just the general soldering stuff. Some flux, thermal paste, tweezers. Solder obviously lol
I have never used flux on wires. Don't forget to put a bit of thermal paste between the host and the mcpcb.
Flux is your friend
to add to this you only need a small ammount of flux for each solder joint. Any excess can be cleaned afterwards using a qtip/cotton bud and some high percentage isoproply alcohol.
Right, I'll just touch the flux to the joint and that's it. Don't like take a big scoop and stack it on there. Just enough to make it a little wet