Main Board Upgrade?

Upgrades & Mods

Currently running a fully stock 5+ aside from Kersey Marlin and octoprint.

Looking at:

SKR 1.4 Turbo

SKR Pro v1.2

SKR Octopus v1.1

SKR Manta m8p/C4

Would prefer a board with 6+ drivers in the event of a move to hydra in the future.

Undecided on Marlin 2.0/2.1 or Klipper at this time. I have both a Pi3 and Pi4 already

Already have a printed bracket for the TFT35.

Trouble is I know there are already pre-compiled firmwares for the 1.4 Turbo which basically makes it a drop in with a printed bracket, but it only has 5 drivers, limiting me to dual-z.

Pro v1.2 or Octopus would be my preference as I already have a Pi thus removing need of the manta, and they offer 6+ drivers.

Other near future upgrades include direct drive with high flow and larger nozzle (0.6/0.8) as this printer will be used for larger prints. Speeds unlikely to exceed 150mm/s

I have no experience with compiling, and time is very limited outside family/work to tinker these days.

Any advice appreciated

Thanks

Posted Oct 31, 2023, 9:40 PM UTC

13
JCB2019r•

If you went with the skr 1.4 turbo, there is an expansion for 3 extra drivers. That would make a total of 8 drivers on the skr 1.4 turbo. Check out the details in the link. https://biqu.equipment/en-au/collections/expansion-board/products/btt-rrf-wifi-v1-0-module-driver-expansion-module-for-skr-v1-4-1-4-turbo-skr-v1-3-3d-printer-part

2