Cisco LISP interface assuming the lowest IP in the VRF

Troubleshooting

LISP SME's seem to be unicorns, so this is a long shot:

We have several vrfs within our LISP wan architecture (ISR-4451's) and traffic is decapsulated from LISP and forwarded over BDI interfaces to their respective VLANs (via a switch module in the 4451s).

The issue: I will use "VRF 100" as the example VRF in this case... So recently, a loopback interface was added to VRF 100 for some kind of connectivity testing that was being done. The LISP0.100 interface has assumed the IP of the loopback, which broke routing for that VRF.

It's not possible to manually configure the LISP0.100 interface. A fellow engineer tells me he remembers fixing this issue in the past, but he couldn't remember what was done. He said it had something to with the LISP interface choosing the lowest IP in the VRF. Is there a way I can change it without changing any IPs (changing IPs would be disastrous, and he said he didn't remember having to change any IPs, so that's out of the question).

If you have any LISP expertise please pm me or reply! Thanks!

Posted Jan 19, 2024, 10:01 PM UTC

22

Comments aren't archived yet

This post had 2 comments on Reddit. Comments for this period haven't been loaded into the archive yet.