How can I make a 50v DC charged battery bank read as 48v?
I have an automatic generator starting system that works by monitoring my lifepo4 48 volt battery bank, and will start a generator when the battery is reach 48 volts. The problem is at 48 volt the batteries are lower than I want them to go, and that's the highest voltage the AGS will start at. What can I do to fool this thing into thinking 50v is actually 48v? In my research I was looking at possibly adding a resistor but I'm not sure what that just be a two volt resistor and would a 2 volt resistor be okay on a lifepo4 battery Bank that can run up to 58.4 volts 100ah while charging? This only goes to a monitoring system so it's not pulling a heavy load.
Posted Jun 5, 2024, 10:28 PM UTC