Unsatisfactory Results Printing Test File: XP Finder with ONYX Impact Plus Resin
I would like to ask if anyone here has experience using ONYX Impact Plus resin.
I'm using the Phrozen Mighty 8K, and I recently replaced the ACF release film. I tested the ONYX Impact Plus resin with the XP_Finder test file, but the results were unsatisfactory. The text on the test print didn’t come out, and the bottom right corner was almost completely flat.
I followed the print settings recommended on the official website.
1.First attempt: Exposure time set to 27.5 seconds.
2.Second attempt: Exposure time changed to 29 seconds. Observed issue: The text still didn’t appear, but the entire piece seemed a bit thicker.
3.Third attempt: Exposure time changed to 25 seconds. Observed issue: Details were very faint and barely visible.
Could anyone suggest adjustments or share their successful print settings and experience with this resin?
Thank you!
4o
Posted Nov 11, 2024, 3:48 PM UTC