r/ps3hacks•1 yr. ago

Frankenstein mod problems

just attempted my first RSX swap on a COK-001 board. I have good ohms on the board, or at least close enough where applicable like RSX PLL, but my system won't boot, here's my syscon bringup

From what I understand, FLEXIO_ID should be solved with the 65nm training data, but it evidently has not been. The error is in BX0, so the system isn't even seeing the new RSX. I confirmed the resistor mods are good, so I don't know why this would be the case.

Anybody have any advice?

>$ bringup
bringup
[SSM] state: 0000 -> 0101
Bringup Mode #0 (0xFF)
[SSM] ssmCb_OnStartingBePowOn() called.
[SSM] Bringup mode : syspm_stat=00000000/00000000
[POWSEQ] PowerSeq_Setup called.
[SSM] state: 0101 -> 0201
[POWSEQ] AV Backend Setup
[SSM] state: 0201 -> 0102
[SSM] state: 0102 -> 0202
[SSM] state: 0202 -> 0103
Press Ctrl+C to exit
>$
[SSM] state: 0103 -> 0203
[SSM] ssmCb_BeforeBeOn() called.
[SSM] state: 0203 -> 0104
Psbd_SbTransMode_Half:0x20e2
[POWERSEQ] Error : BitTraining RSX:RRAC:BX0:BX:FLEXIO_ID
[SSM] state: 0104 -> 0304
[SSM] ssmCb_AfterBeOn2() called.
[SSM] PowSeq Fail : Detected !
[SSM] state: 0304 -> 0700
[POWSEQ] AV Backend Letup
[SSM] Shutdown mode : syspm_stat=00000000/00000000
[ERROR]: 0xa0403034
[POWSEQ] PowerSeq_Letup called.
[SSM] state: 0700 -> 0600
just attempted my first RSX swap on a COK-001 board. I have good ohms on the board, or at least close enough where applicable like RSX PLL, but my system won't boot, here's my syscon bringup

Anybody have any advice?

(PowerOff State) (Fatal)

Posted Dec 29, 2024, 6:30 PM UTC