Turbochef Encore 2 question
I replaced the shut plate service kit on the door. The previous was quite melted and messed up so I couldnt really use it as an example. The new shunt plate does NOT touch the front of the oven no matter how far in you push it with the hinge screws loose. Id say its about .5mm open all the way around fairly even. I cant find any reference in any of the service bulletins about actual alignment or a gap or anything. I assume this is wrong but Id like verification before I chase a windmill. I've watched all the relevant videos on Youtube that I could find and they all literally just say push the door in hard and tighten screw then check with microwave meter. I have one but I haven't gotten to that yet as I wanted to make sure the gap was OK before getting there
Posted Jan 28, 2025, 9:13 PM UTC