Howdy! I acquired a beautiful federal laboratories 201-Z Riot launcher, but unfortunately EGP decided that even though it is not a firearm they should chop off the Hinge arm that extends out from the bottom of the receiver/trigger guard & attaches to the bottom of the barrel, as well as chopping off the two "dog ears" that were located on the top side of the launchers receiver/trigger housing that engage the "T latch" attached to the top of the barrel when closed, keeping the barrel closed securely against the rear half of the launcher when a signal flare is loaded into the chamber and ready to be launched.

Even more unfortunate they didn't include the pieces they chopped off, but they strangely took the time to include the barrel pin

I have scoured the internet for months attempting to find replacement parts so that i can get this beauty put back together, but have have no luck, so i have spent months scouring the internet for usable 3d model files or any type of usable drawings drafted by hand the old fashion way with accurate measurements so i can find someone who can use the files/drawings to make the replacement parts for me, because all attempts I have made to figure out a way to repair the launcher with my basic hand tools & different materials have not been successful. 

I have had someone recommend a website service called send cut send i believe it was called to have the replacement parts made, but I don't have any files or even proper measurements of the missing portions of the launcher to send in to have replacements made, and I am not familiar with how that companies process works. I am not usually one to post things like this online asking for someone to throw me a bone, but at this point I am beyond ready to get this figured out so I can have a launcher that is reassembled instead of being in a box as two seperate pieces to say the least 

At one point I came across a photo of one that a guy had 3d printed the entire rear receiver for and hoped to find out how to get in contact with him to see if he would be willing to help me with my project,  but I have been searching for that photo over the last 2 months and have been unable to find it again. 😅

I hope someone here can help me out or guide Me in the right direction so i can bring this poor mutilated frg back to life as soon as possible. Any and all help will be greatly appreciated. 🙏 


I attached photos showing the launcher and the missing "hinge arm" and "dog ears" i am needing replaced, along with amateur rough sketches showing the damage done by those heartless bassturds and doodles of the missing portions im needing replaced. i did the drawings using my finger and my phones photo editor that is on the same level as paint  on a windows 95 desktop computer. So they look horrible but hopefully you get the idea

Cheers 🍻 

Needing help replacing parts on federal labs riot launcher that was butchered