My microprobe doesn't seem to work HELP!!!!

im running a creality V4.2.7 board and a BTT microprobe this is my probe config

[gcode_macro Probe_Deploy]

gcode:

SET_PIN PIN=probe_enable VALUE=1

[gcode_macro Probe_Stow]

gcode:

SET_PIN PIN=probe_enable VALUE=0

[output_pin probe_enable]

pin: PB0 # PA7 is common for servo (deploy/stow). Verify in your board's pinout.

pwm: True # Enable PWM if you're using a BLTouch or servo-type probe.

cycle_time: 0.001

hardware_pwm: true # Set to True if PA7 supports hardware PWM; False otherwise.

scale: 1.0

value: 0

[probe]

pin: ^PB1 # PA1 is often used for the Z-probe. Use ^ for pull-up if needed (depends on probe).

deactivate_on_each_sample: False

x_offset: -39.4 # Adjust based on your probe's position relative to the nozzle.

y_offset: -1.5

z_offset: 1.460 # Adjust after performing probe calibration (e.g., paper test).

speed: 5.0

samples: 2

samples_tolerance: 0.05

samples_tolerance_retries: 3

activate_gcode:

PROBE_DEPLOY

G4 P500

deactivate_gcode:

PROBE_STOW

G4 P500

[bed_mesh]

speed: 150

horizontal_move_z: 5

mesh_min: 35, 6 # Bottom-left corner of the probing area

mesh_max: 180, 175 # Top-right corner of the probing area

probe_count: 5, 5 # 5x5 mesh grid

[safe_z_home]

home_xy_position: 110, 110 # Center of the bed

speed: 50.0

z_hop: 10

z_hop_speed: 15.0

[screws_tilt_adjust]

screw1: 30, 30

screw1_name: Left-Front

screw2: 190, 30

screw2_name: Right-Front

screw3: 190, 170

screw3_name: Right-Back

screw4: 30, 170

screw4_name: Left-Back

speed: 100

video

horizontal_move_z: 5

screw_thread: CW-M3