Filament getting stuck on nozzle

Over the past two days I've been dealing with multiple problems, most are fixed but I am still having this last issue

My AMS wasn't allowing my to unload filament so I had to take it apart to get the filament out, as I'm doing so I'm checking other problems and it looks like my nozzle is caked in filament. So I heat it up and clean it with a damp towel. I get everything set up and start a test print on no filament is sticking to the plate, but instead is sticking to the nozzle in a clump. I stop the print and take out the .4 nozzle to clean it off and try my other nozzle (thinking if it doesn't work then something else is broken). The .2 nozzle works fine for the same print, so it isn't the plates fault, this was all last night.

I come home from work today after doing some reasesrch, I put back in the .4 nozzle and do a cold pull of the nozzle and the filament comes out clean, I get everything set up and then of auto bed leveling (I saw on another post that this could work) and same result, no filament is sticking to the plate with this nozzle...

I am currently cleaning my plate just in case, I have ordered two more nozzles that come in hopefully soon as I'm in the middle of a print project.

Any help from you guys would be greatly appreciated!