Printer stops extruding for seemingly no reason at the same point

I have an aquila s3, and it works well for small prints, but anything medium or above it stops spinning the gears and no filament comes out. I fixed it for small prints by disabling a software setting, but i cant really find a fix for this.

first print that failed due to the print not extruding

printer nozzle 30 seconds after the print ended (the bit at the end is just because it cooled down and then heated up again)

every print does this at the exact same time. This is the 4th one.

These are my main printer settings

No, its not levelled incorrectly. No, the printer nozzle isnt too low. It just stops extruding. No clog, it just stops rolling the gears.