FINALLY got my FormD T1 working again!

I first off want to thank everyone who has put together build guiders either on YT or here, because I used most of them to build this. Secondly, I want to throw this out in case anyone else has the same issue that I did.

Starting off, the fit and finish of this case is phenomenal. I was able to get the v2.1 from the drop at the middle of August in the US and built it right after I got to college a week later. (This is where my problem started) I turned it on yesterday to start doing homework, and it would start, just not detect my 9070 XT. Tore it apart and put it back into my OG Nr200 and it booted with the 9070 XT, so I figured it was a riser issue. Put the riser in the NR200 and it worked, so I put it all back and cabled it together outside of the T1 and it still worked. After recabling it in the runs I wanted, it would not detect the 9070 XT again. After letting it sit for a few hours, I realized that when I was running the cables, I would repeatedly shift the riser out of the PCIE slot. After tightening that down again, it finally worked. CHECK THAT THE RISER IS FULLY PLUGGED IN!!!!!!!

Specs for those wondering:

CPU: 7600X

CPU Cooler: AXP90-X47 Full Copper

Ram: 32GB DDR5 6000 CL36

Mobo: B650I Lightning

GPU: 9070 XT Steel Legend

PSU: V850SFX

Cables: Dreambigbyray

Let me know if I should change anything! I am thinking of adding fans to the bottom, but I still don't know how hot it will get.