I don’t know, why the images in the first post were deleted… 
If I am doing something wrong, I am terribly sorry..😔 

Hi everyone again, Here is another project of mine, a MOC of the MVG type S tram. The manufacturer is the Swiss company Stadler Rail, and it is part of the Variobahn lineup. The Variobahn is used widely all over Europe (Bochum, Nürnberg, Graz, London, Bergen). It is an articulated low-floor tram and light rail vehicle model.

The original was built between 2008 and 2011. The maximum speed is 60kph, it runs under 750V DC overhead wire and has a length 33,9m.

The MOC is a 7-wide and consists of three parts. In comparison to the original, I have shortend the model (Original is a 5 section tram, front car - floating section 1 - middle section with bogie - floating section 2 - rear car) It has one "floating" middle section which is supported by the front and back sections. It has also a sliding plug door system (which is operated by either a motor or a hand crank). The Power Functions Motor is located in the rear part, the infrared receiver and battery box in the middle. Due to the heavy battery box in the middle it needs a lot of support of the connecting axles.

The most complex part to design was the plug door system. Additionally to the system was the fact that the last door in the rear section has to contra rotate in order to open up into the opposite direction.

Have a good night/evening/day ☺️

Reupload with Images: MVG Tram Type S (Münchner Verkehrsgesellschaft, Munich) Stadler Variobahn