Q2 Nozzle Heat Issue

I am so close to being at my wit's end with this printer. While it does produce great prints, I have nothing but trouble with it. This time I cannot even get the nozzle to start to heat up. I didn't change anything about the printer. I literally just turned it on and I can no longer heat the nozzle.

This is the error: Heater extruder not heating at expected rate See the 'verify_heater' section in docs/Config_Reference.md for the parameters that control this check.

Once the underlying issue is corrected, use the "FIRMWARE_RESTART" command to reset the firmware, reload the config, and restart the host software. Printer is shutdown

If anyone has insight or answers please let me know. I'm pretty sure it has nothing to do with the config that it's referencing because it doesn't even try to heat up. Thank you for your help, otherwise this thing is getting returned.