Mixing Bluetti solar panels

Hi,

New to solar stuff. I'm seeking some clarification about mixing Bluetti solar panels.

I have a PV200L and a SV200L. These panels have exactly the same technical specs listed*
Is it fine to use these panels in series or parallel to charge a bluetti power station? what are the realistic concerns here outside of remaining within the rated input voltage on the power station?

Bluetti says to not mix solar panel models.
Pretty much all the posts I see on forums say it is fine if voltage is "close enough", sometimes citing efficiency concerns.

I was planning to just go for it on the next sunny day, but figured making this post would only take a minute. I'm not rich enough to be unconcerned about damaging this equipment.

*Technical Details as listed:
Peak Power(Pm): 200W
Solar Cell: Mono
Solar Cell Lamination: ETFE
Cell Efficiency: up to 23.4%
Voltage at Max Power(Vmp): 20.52V
Current at Max Power(Imp): 9.75A
Open Circuit Voltage: 24.62V
Short Circuit Current: 10.24A
Operating Temperature: -10C ~ 65C