How to fix this ironing issue?
I thought If I enabled ironing it would smooth out the surface so that i would not see the lines. It does this but it also seems to drag a bit of material with it making the surface look less smooth and a bit messy close-up. To be fair, these are quite small so you do not see it unless looking for it in real life, but I would still like to fix it. It is most visible on the green one.
When I print upside down I need to add support for the keyring loop, otherwise it sags a bit. If I cannot fix the ironing issue I might just do that as on a smooth plate the surface is lovely. I'd rather not waste the filament though, even though it is a miniscule amount.
More pics here - the back is very smooth as it is on the plate.
https://makerworld.com/en/models/1945167-mike-keyring#profileId-2089494
Posted Nov 1, 2025, 1:18 PM UTC