eSun PETG+HS will not detach from textured plate.

I have a bambu lab h2d printer and I'm using the textured plate. I used the standard eSun PETG with no problems at all. The prints stick to the plate but come off easily. I recently bought some spools of the PETG+HS. With this filament, I cannot get the prints off of the plate. I've tried bending the plate and using spatulas, but it's very difficult to get off. To the point where some of my print breaks off and stays on the plate. I've tried turning off the bed heating altogether and still get the same result.

Before I return the unopened filament boxes, do you guys have any suggestions of how to get this stuff to work properly?