r/CarRepair•
docNNST

Different Brake Light Bulbs Masked a Simple Issue (2007 Honda Odyssey)

tldr; All brake lights stopped working, thought no chance all bulbs fried, checked one bulb, LED bulb, checked entire circuit\wiring harness before checking both bulbs. Ended up being one loose LED bulb and a fried filament bulb.

Last week, all the the brake lights on my 2007 Honda Odyssey stopped working. 170k miles, has an oil leak but is a good runner.

The odds of all 3 brake lights failing at once seemed impossible, so I pulled the wiring diagrams off of charm.li and looked for common choke points:

  • Under hood fuse
  • Driver side kick panel fuse (Front MICU)
  • Brake light switch

Pulled one of the bulbs and it was a weird LED one, looked like it was an old school hack job before these were more common

Fuses looked okay and tested with multimeter. Must be brake light switch, super easy to replace, went and bought one and replaced it - Still not working. Thought about it some more and if I was able to shift into reverse, the brake light switch was working.

So back to square one. This indicated that I needed to test the wiring harnesses.

I started up front because I didn't have to take any interior pieces off. Everything checked out. Head to the back. Take a bunch of trim off the cargo area. Get to the rear MICU. Inbound signal from upfront is reading correctly. Pins for out bound are good as well.

So... This would mean that the harness out from the rear MICU is busted or all three lights are fried...

I work in Cyber\IT and when troubleshooting a problem, if based on results of the troubleshooting if the outcome doesn't make sense, you need to test your assumptions. Time to test my assumptions.

I pull the other bulb... the filament is busted. But then I think what are the odds that both an LED bulb and a filament bulb would die at the same time. Test the plugs, have voltage.

Run to the auto parts store, get the bulbs. Replace the fried one, the fried one lights up. Mess with the LED bulb and it was probably lose because it was now working after another jiggle and reseat because it was a hair too small for the socket. I replaced it with the filament bulb and boom both were working.

Small lesson in case anyone runs into something similar in the future.

Posted Nov 13, 2025, 3:26 AM UTC

11

Comments aren't archived yet

This post had 1 comment on Reddit. Comments for this period haven't been loaded into the archive yet.