Buddy3D Cam setup...WiFi connected, but not showing in Prusa Connect App

Basically the title. Have tried multiple times to set up the Buddy3D Cam with my new Core One+, but so far not having much luck.

I first struggled with getting the QR code to show up, and finally realized that was because the Core One was not connected to Prusa Connect because I'd forgotten to give it a reserved DHCP address, and it changed addresses on me.

Once I fixed that, I could pull up the QR code to show the camera in the Prusa Connect app, and the camera said "QR Code Scanned." and "Stop scanning QR code." and then nothing. No chime, no other indication of success. But if I restart the camera, or power the printer off and back on, the camera does say "WiFi connection successful."

But...no camera shows up in Prusa Connect app.

Any suggestions for troubleshooting?

I can reach out to support on Monday, but hoping to get it resolved sooner rather than later.