Creality update to 1.1.4.8 is not ready for primetime

I knew better than to update and had I seen that it was beta I would not have. My printer K2_Plus has been running fantastically (minus user errors) for months now. I updated to the latest firmware and the CFS melted a flat spot in the filament as it was feeding. I did a 4 color print and at every color change it would fail, say there was something jamming the filament and then I would pull the filament back out, find the flat spot cut it, retry and it would feed fine until the next color change. I tried a factory reset but that did not fix the issue, I reverted back to 1.1.3.13 and so far it is running fine. If that changes I will update this. Hope this helps