Please help... 🙏 Bed pretty flat but still nozzle too far in a corner and too close in an other...
Hello!
Following my previous post, I managed to flatten my heating bed with heat resistant tape.
Here is what it looks like now :
Pretty OK, right?
But no matter what I do (playing with flow, line width, anything...), I still have holes between the lines in the first layer in the top right corner, and a big part of the bottom has the nozzle way too close and the PETG looks horrible...
No matter if I increase the height of the top right corner (a little or a lot) I still have the same result.
Bed is sooooaked warm, 70°C for hours, I did dozens of mesh calibration with Fluidd.
Plus calibration at the beginning of every print.
See the pictures :
Any idea what to try?
I'm a bit desperate...
I need to print using all the bed space I can have so from top to bottom, left top right, I cannot just avoir one of the corners.
Thanks! :)
Posted Mar 5, 2026, 8:00 PM UTC