This is my first bike. I was wondering what you guys think will revive this old bike? I bought this bike from my brother he doesn’t care for motorcycles. It didn’t start at all when I got it. Only the two front blinker lights came on but did not blink. The dash lit up but that was about it. The signal 10 A fuse kept blowing then I replaced a few parts now it does not blow anymore, the dash shows neutral and the gas light comes on when trying to start it but it’s still silent. The Killswitch didn’t make any noise before now it does. A clicking noise in the regulator. Also the horn works now. It did nothing else. I replaced the starter solenoid. It was very rusty. I replaced the flasher relay which was also very bad. I replaced the ecu ignitor, the battery, fuses, some splices, ignition coils with spark plugs. I’ve only replaced one spark plug but the others look good, I cleaned the gas tank really well and rebuilt the carb. I have the boots for the filter box coming in the mail because they don’t fit the bike anymore and I cut them trying to get them on so I can’t resize them. I have a new air filter coming in and the main relay is still being shipped. I also replaced the fuel filter and voltage regulator rectifier. I think I either installed the flasher relay wrong or got the wrong one it would buzz and make the front blinkers blink at the same time but nothing else’s. I rotated the wires on the nipple things on the flasher relay now it doesn’t seem to do anything. Any suggestions to get this fossil to start? 

Yamaha xj600 seca 2 1996 not starting / First Bike