Ender 3v2 + SKR3EZ + Eddy Duo + Klipper + Individual Z + Z tilt + Screw tilt adjust says right side is low after every z tilt.

As the title says, after every z_tilt klipper says my right side is low every time after I run a z_tilt.
And it shows in the first layer of every print as well. The left side is barely sticking, the middle is spot on, the right side is to high.
I've been at this for over a month now, and I cant find the freaking problem.
Right side is 0.10-0.12 low every time.
The gantry is true, the wheels are true, EVERYTHING is straighter than a gay guy in the 1920s. All the cables are fine, and everything is working except that it "thinks" the right side is 0.10-0.12 low on every print, so the first layer gets fricked-up.

Its an ender 3v2 running klipper on a pi5 with skr3ez board with tmc2209ez steppers, eddy duo on usb, dual z on individual steppers, and both steppers are configured correctly as well as z_tilt. I have confirmed that the left stepper is Z and the right Z1, as well as the coordinates for each stepper.
I've tried flipping my PEI spring steel sheet but its the same results.
All the wheels have equal contact over all the movments as well.
My PEI springsteel plate + magnet plate are from 3djake, and the only real culprit left is the magnetic sticker? If somehow its magnetic force is different on the right side?

I need help! I've tried everything I can think of, and I'm stuck.
(Before anyone says anything, I know i could've bought a new printer and gotten the same print results, but where's the fun in that?)