Anycubic Kobra X + OrcaSlicer 2.3.2 on Linux — Temperature not changing after leveling (Clog error)

If you're using OrcaSlicer on Linux with the Kobra X and the nozzle stays at 140°C after leveling and gives a Clog error, here's the fix.

 

**The problem:**

The Kobra X runs Klipper firmware (not Marlin). G9111 is a proprietary Klipper macro that handles the entire start sequence — leveling, temperatures, wait position. OrcaSlicer was set to Marlin flavor and was inserting M190/M104 commands before G9111, which interfered with the sequence.

 

**The fix — two steps:**

 1. In OrcaSlicer go to **Printer Settings → General → Firmware** and change G-code flavor to **Klipper**

 

2. Use this Start G-code:

G9111 bedTemp=60 extruderTemp=220

M117

G90

G21

M83

G1 Y1.0 Z0.3 F1000

G92 E0.0

G1 X205.0 E19 F1000

G1 Y1.6

G1 X5.0 E19 F1000

G92 E0.0

G1 Y2.0 Z0.2 F1000

G1 X65.0 E9.0 F1000

G1 X105.0 E12.5 F1000

G92 E0.0

```

 

* Replace 60 and 220 with your bed and nozzle temperatures.

 

**Key point:**

Do NOT put M190 or M104 before G9111. Let G9111 handle everything — that's exactly what Anycubic Slicer Next does internally.

 

Tested on Linux Mint with OrcaSlicer 2.3.2. Hope this saves someone hours of frustration!