Hi all!  

Wanted to share the life improvement we made to our joint packing. I used to roll and roll and roll and roll and roll.

We found a free 3D print file for a device that’s intended to fit on one of those science laboratory devices that’s shakes?   anyhow.

In the second file you can see the side of the device with the bigger holes where you drop your raw, bamboo, blazy susan etc papers of choice that are the correct size. Then you grind your weed and pour into the cup and start packing!  

once your papers are packed and filled. ;

flip the device over into your favorite joint serving dish and get a poker that’s about the thickness of a a tip in this case.  There’s small holes on the other side that you poke the filter side of the joint with to release it. 

then lift like in the gif and have yourself an even better party

How to get a thingy? 

There’s likely tons of sites online for you to send a 3d print request to and get a print back.  

Papers? 

I’d almost recommend buying online by the way.  In the cities here there’s quite the mark up on them

There’s no one brand either.  Like raw joints often can burn a little funny and are easy to over pack so it’s harder to pull.  Blazy susan’s don’t feel like they pack right but every time their burn and pull feels better.  Bamboo i’ve used a lot and found they burned better than raw but could be over packed and harder to pull.

How many?

This device makes 21 at a time i think. 

21 \* 0.75g is about 15.75g of weed estimated to fill it.

Why?

girls need their meds

Hope this was new or interesting for  folks! 

<333

The magical moment <33 or a neat way to pack your 1 1/4” papers