So first off, I would like to say that I am very bad with electrical stuff in general, unless it’s the most basic things. Long story short, the wiring for the blinkers and running lights was broken in places I can’t get to without pulling the bike apart to cut the electrical tape that’s wrapped around everything off to find the wire in a bundle of like 20 other wires. So I decided the easiest thing to do since I don’t have any plans for a full teardown (nor do I have the shop for it) was to simply splice new wire from the signal lights to where they’re supposed to go. This worked wonderfully, and I had the wire tied into the power wire coming out of the fuse box for the blinkers, but for some reason the other night it decided to have a meltdown and I guess overload the electrical system which meant I had no lights at night. Now, after replacing all of the fuses and making sure the battery is all right I turned it on and everything is working now, except for the signal lights. The bulbs are all fine. I already checked. The wire isn’t broken in any places all the connectors are where they are supposed to be, and I even use the multi meter to make sure there was power going to them. But they will not light up. What is wrong with it? I have no clue at this point right now it’s connected to the accessory, but I checked that with the multimeter as well and there is enough power coming from it to power the lights so I don’t know what’s wrong.

\-again you don’t have to tell me how badly done this is. I know it’s very shoddy work

Wiring and electrical stuff.