I recently changed a bunch of old T12 fluorescent fixtures over to LED bulbs but each tombstone on those set ups had a hot and a neutral. It was simple to swap out those old ballast units over to LED.  

In my house, they are different tombstones where one side has both hots and the other side has both neutrals.  I'm hoping its as easy as it looks that I can simply connect one nuetral down to the end where the the two tombstones are jumped and then feed the hot wire to the two blue wired tombstones.  Does this make sense?  These are T8 type B replacement bulbs by Feit.  There is nothing on the package or instructions about the tombstones other than feed a live wire to one side and nuetral to the other.  

I did test this and put in the lights and everything works but I've seen lots of pictures of people's LED's melting so I'm a little concerned about the neutral end being jumped like this.  This is how they were originally set up from the factory so I'm assuming its OK in this set up as well.  Can anyone give me peace of mind that this is correct?  Thank you in advance.

Link to the bulbs is here.

https://www.homedepot.com/p/Feit-Electric-32-Watt-Equivalent-4-ft-White-Linear-Tube-T8-T12-G13-Type-B-Ballast-Bypass-LED-Light-Bulb-Daylight-5000K-10-Pack-T48-850-B-LED-10/325988245

Confirm this fluorescent to LED tombstone wiring.