Is this because of wet filament or another slicer issue?
I am very new to 3D printing and Elegoo CC1 is my first 3d Printing.
I am trying to print this shelf for CC1 - https://makerworld.com/en/models/1615230-elegoo-centauri-carbon-right-side-shelf?from=search#profileId-1704343
Printing in PETG is not clean and has a few artifacts (not sure what else to call them). Is this becasue of wet filament or a model issue or a printer issue. Tried printing it twice and has almost the same issues at the same places in the model.
I usually get stringing with PETG, but nothing like this. Its been very humid in melbourne the last couple of days (60 - 90%)s so I am not sure if its just wet filament.
Printer: Elegoo Centauri Carbon 1
Filament: Jayo Orange PETG
Hot end Temp: 255° C
Bed Temp: 70° C
Flow rate: 18 mm³/s
Posted Jun 5, 2026, 4:40 AM UTC