Ender 3 Pro help

Hey all, my Ender 3 pro has been out of commission for a while because of an issue I’m running in to. For more context, I have a BLtouch installed and prior to me moving, everything was working normally without issue.

After moving, I wanted to relevel the bed and make sure everything was dialed back in because moving the printer in my car probably messed some things up. I went through the normal leveling process and did the BLTouch level check. All seemed OK. I load up benchy and hit print and the printer homes, BLTouch check, and then raises the Z axis an inch off the bed and starts to print spaghetti.

I’ve checked the g code, tried a different benchy, and everything, nothing out the ordinary. What seems to be happening is that when doing its starting checks Z = 0, but then when it starts to print it seems to think that 0 is an inch off the bed. I’ve already tried factory resetting the ender and going back through setup and it still has the issue.

Has anyone run into this and know a fix or what I’ve done wrong? If more info would be helpful let me know I’ll provide any info I can