This was by far the most complications I've had while assembling a KO set. It drew blood a few times, lots of incorrect molds requiring some DIY to make them fit, a couple nonessential bits missing. Stuff like the UCS plaque being miscolored, and misaligned printing I was expecting with this set, however the tolerances made any of the technic assemblies a major PITA to assemble. Lots of inconsistent tolerances on the bits leading up the wings making the gun assemblies prone to falling off. There were constantly bits I needed in future bags leading me to think I was missing more pcs than I was by the very end. 



Was given a partial refund cause of the missing bits. Total cost after the partial was $14.56, before refund I spent $26.94. To give credit where credit is due the interior/cockpit stickers were very high quality (pic of sheet attached). The bits holding the wings on had solid enough tolerances where the wings do not try and droop out of the set position. Bought off aliexpress. This is the first time I've done a review for a set and the listing hasn't been taken down yet. [https://a.aliexpress.com/\_mNsuyLh](https://a.aliexpress.com/_mNsuyLh)



6/10 it's a pretty faithful replica but it took more DIY to get the out of spec parts to work compared to the Sian 1:8 set. Inconsistent tolerances combined with these issues mean I cant rate it higher in good conscience. 

UCS TIE Interceptor #75382