WebUI loads but after logging in nothing happens

Hi all,

Bit of a weird one, after a couple of previous resolved issues including a motherboard and PSU replacement my server has been running Smoothly.

My previous motherboard had a built in 2.5Nic but the new one is only 1Gig. I purchased a 2.5Gb usb NIC and it was originally only being picked up as 1gig until I ran this command from the command line (ethtool-s eth1 speed 2500 duplex full autoneg off)

Once I don’t this the NIC was working at 2.5 even after a server reboot.

Anyway I can only think it’s this that is now causing the issues I face. I can hit the server with the ip address and the login page shows up, I can enter the credentials and then it tries to load but nothing happens. My Immich container works if I log into that and if I connect with Tailscale it shows as online and I can gain hit the webpage but it won’t load in.

I SSH’d into it and rebooted it and it’s the same but now I can no longer ssh into it unless I do a hard reset.

Any ideas