After sharing the work in progress a while ago, I'm happy to finally share the finished version of FilaDock!

FilaDock is a modular filament management system designed for the INDX and built around an IKEA SKÅDIS medium pegboard.

The goal was to create a clean and practical way to organize the complete filament setup, including mounts for the original INDX filament sensors and a tidy Bowden tube routing solution.

The final design fits 8 filament spools on the medium SKÅDIS board (4 on each side) and keeps everything together in one compact setup.

Some details:

* Designed for the IKEA SKÅDIS medium pegboard
* Holds 8 filament spools
* Includes mounts for the original INDX filament sensors
* Uses a snap-fit design for the spool holders
* Printed in PETG
* Around 900g of filament for the complete system

The spool holders are designed with tight tolerances to create a secure snap-fit connection. Depending on your printer's calibration, you may need to press the parts together firmly (or use pliers carefully) until they click into place.

[The model is now available on Printables. ](https://www.printables.com/model/1798818-filadock-modular-filament-hub-for-indx-ikea-skadis)

Thanks to everyone who followed along with the development and gave feedback on the WIP post. Would love to see your setups if you decide to build one!

I finally finished my INDX filament management system – FilaDock (IKEA SKÅDIS + sensor mounts) - now on Printables