Potential buyer trying to break the laws of physics.
Listed some antique round drawer pulls that were 1.6875" in diameter. Kinda like these:
A bit of an oddball because they use 2 mounting screws vs one.
A buyer messages me and asks what the center to center for the holes are, which was almost 1.5".
Then they reply "oh darn, I am looking for round pulls that are 2" center to center"
My brother in Christ, if the entire pull is 1.6875" in diameter, how on earth can the mounting holes be wider than the entire pull?
Posted Aug 10, 2026, 4:21 PM UTC
11