Struggling to level a Bambu P2S
I am helping a client get their Bambu P2s running. It looks to me like the build plate isn't level. By eye I can see that the rear left is higher than the rest of the plate, and there is a scratch in the plate that may have been done by the nozzle.
- I've run the auto calibration and it gets stuck on the auto level step.
- I'm trying to manually adjust the plate per Bambu's instructions on this site (https://wiki.bambulab.com/en/p2s/maintenance/manual-bed-tramming) and the print stops when trying to run the manual level g-code file.
I am very new to FDM printers, what suggestions do you have for me to get this thing calibrated and running?
Attached is a photo of the build plate... I am not sure if it's clear, but it really looks like it's higher on the left hand side.
Posted Aug 12, 2026, 8:17 PM UTC