**Looking for compatible rails for this Tiger 4U server**  
I recently picked up this **Tiger 4U rackmount server on eBay for under $200 CAD**, and I’m trying to identify the correct rail kit for it.  
Here are the specs as far as I’ve been able to determine:  
**Chassis:** Tiger tbox556222 Rev. 1.2  
**Form factor:** 4U  
**Drive bays:** 16 × 3.5” HDD bays  
**Motherboard:** Supermicro X8DT6 / X8DTE  
**CPU:** Intel Xeon E5620 currently installed (CPU1)  
**CPU sockets:** 2 × LGA1366  
**RAM:** DDR3 ECC Registered  
**PSUs:** 2 × FSP Group 720W 80+ Bronze hot-swap PSUs  
**SAS controller:** 4-port SAS card  
**Networking:** 4-port Gigabit Ethernet card, with plans to add 10GbE  
**IPMI:** IPMI 2.22  
**BIOS:** 2.0c (05/15/2012)  
**Depth:** approximately 25.5”  
My plan is to turn this into a **Proxmox/Ceph server** and upgrade it considerably. I’m planning to add a second **Xeon L-series CPU** for lower power consumption, install a second CPU cooler, and max out the RAM to approximately **196 GB DDR3 ECC Registered**.  
The main thing I’m trying to figure out right now is the **rack rails**.  
The server currently has part of the rails attached to the chassis. The markings on the existing rails appear to be **Dynaslide 05-14**, but I’m missing the other half that attaches to the rack.  
Does anyone recognize this Tiger chassis or know the **exact rail model/part number** that is compatible with it?  
I’ve found several possible 4U ball-bearing rails, including SilverStone RMS03-26 and some Supermicro/Chenbro rails, but I’d rather find the original or properly compatible rails if possible.  
**Any information on the Tiger chassis or the correct rail kit would be greatly appreciated!**

Hot eBay deal.