My H2D is receiving partial power but will not complete startup.
My H2D is receiving partial power but will not complete startup. The issue began immediately after, or very shortly after, a recent firmware update.
Current symptoms:
Toolhead lights turn on.
The front bed status/light bar turns white.
The touchscreen remains completely black with no visible boot screen.
The printer cannot be found or connected to through Bambu Studio or Bambu Handy.
The printer does not complete normal startup or accept commands.
Troubleshooting completed:
Turned the printer off and unplugged it.
Left the printer unplugged for approximately 20 minutes before restarting.
Cycled the rear power switch.
Removed all USB devices before attempting startup.
Reseated the safety connector.
Disconnected the AMS 2 Pro completely from the printer.
Connected only the factory power cable directly to a wall outlet, bypassing my UPS/power backup unit.
Attempted startup with no AMS, USB devices, or other external connections.
The same issue persists: toolhead lights and the white bed status bar activate, but the touchscreen remains black and the printer stays offline in both Bambu Studio and Bambu Handy.
Because the issue began shortly after a firmware update, and both the touchscreen and network connection are unavailable, I believe this may be a failed firmware boot or a controller-related issue.
Any suggestions would be great as i wait for my ticket.
Posted Aug 30, 2026, 1:42 AM UTC