Leaking faucet for a washing machine

I just got my first washing machine but noticed that when I turned on the hot and cold faucet that they leaked from the stem considerably and needs replacing. It looks like the fitting was soldered on to the pipe. I've sweated off a fitting before but on an exterior wall, how easy would it be to replace them both or would I be better off hiring a plumber?

Posted Apr 2, 2014, 12:08 AM UTC

128
twardnw•

See if you can pull a brand name and part number off the valves, many of them are rebuildable. Find a good plumbing store nearby and they'll get you the parts needed.

2
stagueUnited States - Northern Rockies•

Agreed on the plumbing supply. I recommend bringing the parts you intend to replace with you.

Also, you should know that washing machines now require hammer arrestors and they sell valves that have one built in. If you buy a new valve you should move in this direction.

1
mousehorse•

photo?

2
stagueUnited States - Northern Rockies•

What kind of valve is it? If it is a ball valve (takes 90 degree turn to close/open the valve) then you can tighten that connection:

  • Remove the nut/screw holding the lever on.
  • Pull the lever off.
  • Under the handle there should be a skinny nut or at least a pair of parallel flat sides that you can get a crescent wrench on (a box end wrench would be better).
  • Snug this nut gently until the leaking stops. I want to stress that tighter is not better here, just snug it so it stops the weeping.

If you have a gate valve (round handle that takes many turns to close the valve) then you should replace it with a ball valve anyway (I think code requires a ball valve here anyway).

You say that you have sweated copper before so this is totally in your grasp. Use a wet rag over anything you don't want on fire.

1
JRochOP•

It's a gate valve but I'll replace it with a ball valve, those seem more durable anyway. Thanks for the advice!

1
stagueUnited States - Northern Rockies•

Don't forget to have a look at hammer arrestors while you are looking for a valve. A plumbing supply shop should sell ball valves that have a hammer arrestor integrated into the unit.

1
JRochOP•

Will do, it sounds like a project for saturday!

1
stagueUnited States - Northern Rockies•

The plumbing supply in my town is only open during the week. YMMV.

1
Legion1107•

Did you try tightening the packing nut?

1